Bucket Elevator Shaft Seal Design Quadruples Head and Tail Pulley Bearing Life

 


 

Abstract:

Bucket Elevator Shaft Seal Design Quadruples Bearing Life. Dust ingress into bearings is one of the great causes of premature bearing failure on bucket elevators. By selecting the right bearing housing and position, combined with this special dust seal arrangement, you can get quadruple the bearing life. The article provides the full details of the low pressure dust leak seal design along with a sketch of the successful set-up.

Keywords: bucket elevator shaft seal, bearing dust seal, dust leak protection, bearing housing dust seal.

Below is a sketch of a dust seal arrangement that tripled the bearing life of the bearing in the housing. It went from 12 months at best to over 4 years without a failure. Combining the end cover sealed bearing housing mounted off the elevator frame with this separate dust seal arrangement where the shaft entered the frame, it more than quadrupled bearing life.

You will need to make the seal housing that mounts to the bucket elevator, or to any low shaft velocity – low pressure dust leak situation, from commercially available carbon steel. The secret behind its success is that the primary seals are in a separate housing to the bearing and provide multiple and redundant sealing before the dust can escape the bucket elevator.

Bucket Elevator Shaft Seal Design Quadruples Bearing Life

Disclaimer: Because the authors, publisher and resellers do not know the context in which the information presented in this article is to be used they accept no responsibility for the consequences of using the information contained or implied in any articles.

P.S. If you have maintenance engineering advice on industrial equipment maintenance, especially defect elimination and failure prevention of plant and equipment, or have made successful equipment reliability improvements, please feel free to send me your articles to post on this website. You can contact me by email at info@lifetime-reliability.com